DEBURRING TOOL – FLEX-HONE FOR EASY DEBURRING, AUTOMATION & BETTER METAL FINISHES
Easier to use deburring tools. Wide range of sizes from Australia’s authorised importer. Deburring machines for finishing metal or hand deburring can all be speeded up with Flex-Hones used as your best efficiency improver in deburring tools.
Before flex-Honing
After flex-Honing
Picture at below shows how a set of contra-rotating Flex-Hones beats burrs in a 2 stroke cylinder
A specially made piece of equipment to hold 2 Flex-Hones side by side was the solution for this 2 stroke engine manufacturer. By rotating one hone clockwise and the other one anticlockwise you can beat burrs on both sides of a machined cross hole in any bore. The operator in this case gives a few seconds of honing as illustrated below and then swaps the positions of the right and left hand cylinders and hones for a few more seconds– – And presto – the ports are deburred on both sides. Although this was a manual operation it was more efficient than other practices.